We will reply to your message within an hour.
Snap these grommets into place to hold wire, cable, and cords in wet locations and form a seal against dust, debris, and water.
Support shafts, bearings, and other moving parts that are routed through a hole. These grommets are slippery to allow parts to move freely in the hole. Install them on thin sheet-metal panels.
Extend your cord’s life while stopping it from coming loose in places that are sanitized with water or steam as hot as 300° F, such as food plants and clean rooms.
Wrap the split gland of these grips around ethernet cables with an RJ45 connector or other already installed cables for a water-resistant seal with your enclosure.
Able to withstand temperatures up to 300° F, these grips are also corrosion- and chemical-resistant.
A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.
Vent air from your enclosure to equalize pressure and stop condensation from forming inside while securing cords in wet environments. These polyamide grips are lightweight and resist rusting.
Secure cords installed through enclosures and panels in wet environments while protecting them against sharp bends. With a flared end that keeps cords from bending without limiting too much motion, these grips extend cord life.
Tighten the screw-down clamp for superior pull-out resistance.
Suitable for use in applications where cords are underwater—these grips are rated IP68 for protection from prolonged submersion.
Keep cords from coming loose and seal water out of enclosures in extremely cold labs and storage areas. Thanks to their plastic bushing and rubber O-ring, these grips withstand temperatures as low as -75° F.
Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.
These grips are the most corrosion resistant of any of our submersible metal cord grips.
These cord grips are lightweight yet durable.
Stainless steel construction offers the most corrosion-resistance of any of our multi-diameter wet-location cord grips.
These grips are nickel-plated brass for good corrosion resistance.
Attach a cord grip to cable without removing connectors and rewiring. These cord grips have a two-piece design to fit around cables with connectors.
Modify these cord grips to get the right fit for your cord even when you don't know the exact diameter.
The face of these grips is flush with the cable-entry point for a seamless appearance.
Snap these nuts into square holes in thin materials.
Stainless steel snap-in nuts have excellent corrosion resistance in most environments.