Search Results
    Clear All
    Trade Number
    Trade Number
    default
    625
    625-2RS
    625-2Z
    System of Measurement
    System of Measurement
    Metric
    For Shaft Diameter
    For Shaft Diameter
    5mm
    For Housing ID
    For Housing ID
    16mm
    Width
    Width
    default
    5mm
    Ring Material
    Ring Material
    Stainless Steel
    Plastic
    Ball Bearing Type
    Ball Bearing Type
    Standard
    OD
    OD
    16mm
    ID
    ID
    5mm
    Seal Type
    Seal Type
    Open
    Sealed
    Shielded
    Inner Ring Type
    Inner Ring Type
    Standard
    Bearing Type
    Bearing Type
    Ball
    For Shaft Type
    For Shaft Type
    Round
    Lubrication
    Lubrication
    Lubricated
    Required
    Not Required
    Maximum Speed
    Maximum Speed
    2,300 rpm
    36,000 rpm
    43,000 rpm
    For Load Direction
    For Load Direction
    Radial
    Dynamic Radial Load Capacity
    Dynamic Radial
    Load Capacity
    Less than 1,000 lbs.
    Cage Material
    Cage Material
    Stainless Steel
    Plastic
    Ball Material
    Ball Material
    440C Stainless Steel
    316 Stainless Steel
    ABEC Rating
    ABEC Rating
    ABEC-3
    Not Rated
    Shaft Mount Type
    Shaft Mount Type
    Press Fit
    Maximum Radial Clearance
    Maximum Radial Clearance
    0.007"
    0.013mm
    0.2mm
    Minimum Radial Clearance
    Minimum Radial Clearance
    0.001"
    0.002mm
    0.025 mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    5 Products