Search Results
    Clear All
    Trade Number
    Trade Number
    default
    626
    626-2RS
    626-2Z
    System of Measurement
    System of Measurement
    Metric
    For Shaft Diameter
    For Shaft Diameter
    6mm
    For Housing ID
    For Housing ID
    19mm
    Width
    Width
    default
    6mm
    Ball Bearing Type
    Ball Bearing Type
    StandardFlanged
    Seal Type
    Seal Type
    Open
    Sealed
    Shielded
    Ring Material
    Ring Material
    Steel
    Stainless Steel
    Plastic
    OD
    OD
    19mm
    ID
    ID
    6mm
    Bearing Type
    Bearing Type
    Ball
    For Load Direction
    For Load Direction
    Radial
    For Shaft Type
    For Shaft Type
    Round
    Inner Ring Type
    Inner Ring Type
    Standard
    Dynamic Radial Load Capacity
    Dynamic Radial
    Load Capacity
    Less than 1,000 lbs.
    Shaft Mount Type
    Shaft Mount Type
    Press Fit
    ABEC Rating
    ABEC Rating
    ABEC-1
    ABEC-3
    Not Rated
    Cage Material
    Cage Material
    Steel
    Stainless Steel
    Plastic
    Lubrication
    Lubrication
    Lubricated
    Required
    Not Required
    Maximum Radial Clearance
    Maximum Radial Clearance
    0.01mm
    0.023mm
    0.12mm
    0.177mm
    0.2mm
    0.2032mm
    Minimum Radial Clearance
    Minimum Radial Clearance
    0.005mm
    0.008mm
    0.025mm
    0.0254mm
    0.026mm
    0.04mm
    Static Radial Load Capacity
    Static Radial Load Capacity
    Less than 10,000 lbs.
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    12 Products