Plain Bearing Type Plain Bearing Type |
---|
![]() | Flanged |
Material Material |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
![]() | Slip Fit |
For Load Direction For Load Direction |
---|
![]() | Combined Radial and Thrust |
For Housing ID For Housing ID |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Show |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Hide |
---|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
Filler Material Filler Material |
---|
|
Lubrication Lubrication |
---|
|
About Plain Bearings
More
Light Duty Dry-Running Flanged Sleeve Bearings

Use where high loads and speeds are not required.
Thermoplastic-blend bearings have low moisture absorption and create very low friction in applications with light loads, and frequent starts and stops.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
For Housing ID | Lg. | Flange OD | Flange Thick. | Dynamic Radial Load Capacity | Dynamic Thrust Load Capacity | Color | Temperature Range, °F | Each | |
Thermoplastic-Blend Bearings | |||||||||
---|---|---|---|---|---|---|---|---|---|
For 20mm Shaft Dia. | |||||||||
23mm | 11.5mm | 30mm | 1.5mm | 270 lbs. @ 60 rpm | 310 lbs. @ 60 rpm | Yellow | -50° to 190° | 00000000 | 00000 |
High-Speed Self-Aligning Dry-Running Flanged Sleeve Bearings


Made of acetal with a PTFE filler, these bearings handle velocities up to twice as high as standard acetal bearings. They’re self-lubricating, so they’ll take on less wear for an increased lifespan. Acetal won’t warp or swell from exposure to water, so these bearings are good for use in washdown environments. These bearings swivel to compensate for a small amount of shaft misalignment. Designed for press-fit installation by hand—no tools required—they don’t need to be fitted into a housing. Mount them into injection-molded panels and mounts, thin sheet metal, or hard non-ductile materials.
For technical drawings and 3-D models, click on a part number.
For Shaft Diameter | Length | Flange OD | Flange Thickness | Dynamic Radial Load Capacity | Dynamic Thrust Load Capacity | Misalignment Capability | Color | Temperature Range, °F | Each | |
PTFE-Filled Acetal Plastic Bearings | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
5/8" | 49/64" | 1 1/8" | 1/32" | 270 lbs. @ 60 rpm | 270 lbs. @ 60 rpm | 5° | Black | -40° to 180° | 0000000 | 000000 |