Clear All
Bearing Trade Number Bearing Trade Number |
|---|
System of Measurement System of Measurement |
|---|
|
For Shaft Width For Shaft Width |
|---|
|
Ball Bearing Type Ball Bearing Type |
|---|
 | Standard |
Hex Width Hex Width |
|---|
|
Lubrication Lubrication |
|---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Show |
|---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Hide |
|---|
Warning: Products have one, but not necessarily all, of the selected characteristics.
Inner Ring Width Inner Ring Width |
|---|
|
Inner Ring Type Inner Ring Type |
|---|
 | Extended |
Seal Type Seal Type |
|---|
|
For Load Direction For Load Direction |
|---|
 | Radial |
Cage Material Cage Material |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Ball Material Ball Material |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
About Ball and Roller Bearings
More
Hex-Bore Ball Bearings
Mount these bearings onto a hex shaft. All have an extended inner ring for additional shaft support. Seals keep out dust and contaminants.
For technical drawings and 3-D models, click on a part number.
Inner Ring | Radial Load Cap., lbs. | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Bearing Trade Number | For Shaft Wd. | Hex Wd. | For Housing ID | Wd. | OD | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | ABEC Rating | Each | |
Sealed | |||||||||||||||
| 207 | 1 1/8" | 1.126" | 2.8346" | 0.67" | 1.76" | 1.484" | Steel | 5,800 | 3,450 | 4,000 | Not Required | -40° to 250° | ABEC-1 | 000000 | 000000 |
Precision Needle-Roller Bearings
Bearing
Shaft Liner
Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.
Sealed bearings block out dust and other contaminants.
Shaft liners allow you to use the bearing on unhardened and unground shafts.
For technical drawings and 3-D models, click on a part number.
Bearings | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Radial Load Cap., lbs. | Optional Shaft Liners | |||||||||||||
| For Shaft Dia. | For Housing ID | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range., °F | Each | For Shaft Dia. | Each | ||
Sealed | ||||||||||||||
| 1" | 1 1/2" | 1" | Steel | 5,800 | 7,100 | 3,800 | Lubricated | 12 | -30° to 250° | 0000000 | 000000 | 3/4" | 0000000 | 000000 |