Clear All
System of Measurement System of Measurement |
---|
|
Ball Bearing Type Ball Bearing Type |
---|
![]() | Standard |
For Load Direction For Load Direction |
---|
![]() | Radial |
![]() | Combined Radial and Thrust |
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Show |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Hide |
---|
Warning: Products have one, but not necessarily all, of the selected characteristics.
Bearing Trade Number Bearing Trade Number |
---|

Cage Material Cage Material |
---|
|
Construction Construction |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
Maximum Speed Maximum Speed |
---|
|
Seal Type Seal Type |
---|
|
Lubrication Lubrication |
---|
|
Ring Material Ring Material |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Minimum Temperature Minimum Temperature |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Ball Material Ball Material |
---|
|
About Ball and Roller Bearings
More
Self-Aligning Ball Bearings

Open
With a spherical raceway and two rows of balls, these bearings compensate for shaft misalignment.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Bearing Trade Number | For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Misalignment Capability | Temp. Range, °F | ABEC Rating | Each | |
Open | |||||||||||||
2207 | 35 | 72 | 23 | Steel | 6,750 | 1,950 | 12,000 | Lubricated | 2.5° | -30° to 210° | ABEC-1 | 0000000 | 0000000 |
Combination Ball/Needle-Roller Bearings


A built-in thrust ball bearing reduces wear from adjacent shaft components, while the needle rollers support high radial loads. Install anywhere you would use separate bearings for radial and thrust loads.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | Thrust Load Cap., lbs. | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ball Bearing OD, mm | Ball Bearing Wd., mm | Ring Material | Dynamic | Static | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range, °F | Each | |
Open | |||||||||||||||
50 | 62 | 35 | 71.5 | 14 | Steel | 6,750 | 15,400 | 6,450 | 13,510 | 4,300 | Required | 8 | -20° to 230° | 00000000 | 0000000 |