Clear All
System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
OD OD |
---|
|
ID ID |
---|
|
Bearing Type Bearing Type |
---|
![]() | Roller |
For Load Direction For Load Direction |
---|
![]() | Radial |
Seal Type Seal Type |
---|
|
Cage Material Cage Material |
---|
|
For Housing ID For Housing ID |
---|
|
Lubrication Lubrication |
---|
|
Static Radial Load Capacity Static Radial Load Capacity |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Show |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity | Hide |
---|
Warning: Products have one, but not necessarily all, of the selected characteristics.
Construction Construction |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Roller Bearing Type Roller Bearing Type |
---|
|
Roller Material Roller Material |
---|
|
Ring Material Ring Material |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
About Ball and Roller Bearings
More
Precision Needle-Roller Bearings

Bearing

Shaft Liner
Install these bearings directly onto hardened and ground shafts. They have higher load capacity, speed, and accuracy than standard needle-roller bearings.
Open bearings dissipate heat more efficiently than sealed bearings.
Shaft liners allow you to use the bearing on unhardened and unground shafts.
For technical drawings and 3-D models, click on a part number.
Bearings | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Radial Load Cap., lbs. | Optional Shaft Liners | |||||||||||||
For Shaft Dia. | For Housing ID | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range., °F | Each | For Shaft Dia. | Each | ||
Open | ||||||||||||||
1 3/4" | 2 5/16" | 1" | Steel | 9,900 | 19,700 | 7,600 | Required | 16 | 0° to 245° | 0000000 | 000000 | 1 1/2" | 000000 | 000000 |