Clear All
System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter | Show |
---|
|
For Shaft Diameter For Shaft Diameter | Hide |
---|
For Load Direction For Load Direction |
---|
![]() | Combined Radial, Thrust, and Moment |
Bearing Type Bearing Type |
---|
![]() | Roller |
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
---|
|
ID ID |
---|
|
OD OD |
---|
|
For Housing ID For Housing ID |
---|
|
Maximum Speed Maximum Speed |
---|
|
Seal Type Seal Type |
---|
|
Construction Construction |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
Lubricant Lubricant |
---|
|
Roller Material Roller Material |
---|
|
Seal Material Seal Material |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
Ring Material Ring Material |
---|
|
Roller Bearing Type Roller Bearing Type |
---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Lubrication Lubrication |
---|
|
About Ball and Roller Bearings
More
Crossed-Roller Bearings

With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Sealed bearings block out dust and other contaminants better than open bearings, but retain more heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Features | Each | |
Sealed | |||||||||||
200 | 226 | 13 | Steel | 5,800 | 12,250 | 175 | Lubricated | 0° to 175° | Lubrication Groove, Lubrication Hole | 0000000 | 000000000 |