Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
ID ID | Show |
|---|
|
ID ID | Hide |
|---|
OD OD |
|---|
|
For Load Direction For Load Direction |
|---|
 | Thrust |
Cage Material Cage Material |
|---|
|
Bearing Type Bearing Type |
|---|
 | Roller |
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Lubrication Lubrication |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Roller Material Roller Material |
|---|
|
Static Thrust Load Capacity Static Thrust Load Capacity |
|---|
|
Seal Type Seal Type |
|---|
|
Washer Material Washer Material |
|---|
|
About Ball and Roller Bearings
More
Needle-Roller Thrust Bearings
Thinner rollers allow these bearings to fit in tighter spaces than tapered-roller thrust bearings. Because of the large contact area between the rollers and washers (not included), these bearings are great for medium to heavy duty, low-friction jobs. For use on hardened and ground surfaces.
Washers allow you to use the bearing on unhardened and unground surfaces.
Bearings
Bearing
Thrust Load Cap., lbs. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | OD | Thick. | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microns | Temp. Range, °F | Each | |
Steel Rollers | ||||||||||
Open | ||||||||||
| 3 3/4" | 4 5/8" | 1/8" | 12,600 | 77,400 | 3,500 | Required | 0.2 | 0° to 240° | 00000000 | 000000 |
For technical drawings and 3-D models, click on a part number.