We will reply to your message within an hour.
Also known as Oilite® bearings.
Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.
For applications with frequent starts and stops, the oil in these bearings contains particles of slippery PTFE that lubricate the bearing during startup.
Graphite provides a layer of dry lubrication that can operate in high-temperature environments.
Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.
These bronze bearings are strong, wear resistant, and excellent at handling shock loads.
A figure-8-shaped groove provides a flow path for lubricant, distributing it evenly along the bearing’s surface.
Create a low-profile conveying surface.
Replace worn or damaged wheel bearings to keep your equipment rolling.
Reduce the inside diameter of a bearing to fit a particular axle size. Also known as spanner bushings.
The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.
Replace worn bushings and quickly change IDs without needing to repeatedly use a lever press. Instead of pressing bushings in and out of your jig fixture, which can cause damage, these bushings slide in and out of sleeves.
Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.
Also known as trapezoidal-thread lead screws and nuts.
Multiple thread channels (also known as thread starts) create faster linear travel than ball screws with a single thread start.