System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
Plain Bearing Type Plain Bearing Type |
---|
![]() | Flanged |
For Housing ID For Housing ID |
---|
|
Bearing Type Bearing Type |
---|
![]() | Plain |
Length Length | Show |
---|
|
Length Length | Hide |
---|
For Load Direction For Load Direction |
---|
![]() | Combined Radial and Thrust |
Lubrication Lubrication |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
![]() | Slip Fit |
Flange Thickness Flange Thickness |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Color Color |
---|
![]() | White |
Dynamic Radial Load Capacity Dynamic Radial Load Capacity |
---|
|
For Shaft Type For Shaft Type |
---|
![]() | Round |
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Dynamic Thrust Load Capacity Dynamic Thrust Load Capacity |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
About Plain Bearings
More
Easy-Install Dry-Running Flanged Sleeve Bearings

A slit running along the length of these bearings allows you to quickly slip them into a housing—no tools required.
Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.
For technical drawings and 3-D models, click on a part number.
For Housing ID | Lg. | Flange OD | Flange Thick. | Dynamic Radial Load Capacity | Dynamic Thrust Load Capacity | Color | Temperature Range, °F | Each | |
Nylon Plastic Bearings | |||||||||
---|---|---|---|---|---|---|---|---|---|
For 3/8" Shaft Dia. | |||||||||
7/16" | 13/32" | 19/32" | 1/32" | 45 lbs. @ 40 rpm | 49 lbs. @ 40 rpm | White | -40° to 400° | 0000000 | 00000 |
Press-Fit Drill Bushings with Head


The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole. Drill bushings can also be used as spacers, shims, and machinery bushings.
Don't see the size you need? Additional sizes are available.
For technical drawings and 3-D models, click on a part number.
Head | Tolerance | Each | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
OD | Lg. | For Drill Bit Size | OD | Thick. | ID | OD | Lg. | Drill Bushing Type | Material | Hardness | 1-5 | 6-11 | 12-Up | |
0.3125" ID | ||||||||||||||
1/2" | 13/32" | 5/16" | 5/8" | 3/32" | 0.0001" to 0.0006" | 0.0014" to 0.0017" | -0.01" to 0.01" | HL | Steel | Rockwell C61 | 000000000 | 000000 | 00000 | 00000 |