Capable of handling temperatures from -400° to 750° F, these graphalloy bearings have the widest temperature range of any of our mounted bearings. They are self-aligning to compensate for shaft misalignment.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.

Bearings are self-aligning to compensate for shaft misalignment. Seals block out dust and contaminants.

Bearings with nickel-plated cast iron housing are more corrosion resistant and durable than bearings with a cast iron housing.

Set screw bearings secure to shafts as you tighten their screw. They don’t need a collar, but the screw leaves some marring on shafts. Use them in applications where shafts rotate in both directions.

Eccentric lock bearings are quick to install—twist them in one direction to tighten and the opposite to loosen. They’re better than set screw bearings for high speed applications, but they only work with shafts that rotate in one direction.

For technical drawings and 3-D models, click on a part number.

Made to withstand frequent washdowns, these bearings are permanently lubricated, which means you’ll never have to add lubricant. Use them in hard-to-reach areas in food, beverage, pharmaceutical, and chemical plants. With a 316 stainless steel housing, these bearings won’t rust from salt water, chlorine, or chemicals. All are lubricated with NSF registered H1 grease, which is certified for incidental contact with food.

Set-screw bearings secure to shafts as you tighten their screw. They don’t need a collar; however, the screws leave some marring on the shaft.

Concentric-lock bearings have a collar that centers and secures the shaft in the bearing bore. To install, tighten the single screw on the collar around its inner ring on your shaft. These bearings have a secure grip on the shaft that reduces vibration and noise.

For technical drawings and 3-D models, click on a part number.

The lubricant in these mounted ball bearings is suitable for incidental contact with food. Bearings are self-aligning to compensate for shaft misalignment.

Steel bearings are stronger than stainless steel bearings, but not as corrosion resistant.

Stainless steel bearings are more corrosion resistant than steel bearings.

Shielded bearings dissipate heat more efficiently than sealed bearings.

For technical drawings and 3-D models, click on a part number.

These bearings have the highest speed ratings of any mounted ball bearing that we offer. The clamp-on collar creates a 360° grip around the shaft for a strong, mar-free hold. Bearings are self-aligning to compensate for shaft misalignment. Seals block out dust and contaminants.

For technical drawings and 3-D models, click on a part number.

Synthetic grease enables these bearings to operate in temperatures up to 400° F—nearly double the maximum temperature of standard mounted ball bearings with four-bolt flange. They are self-aligning to compensate for shaft misalignment. Seals block out dust and contaminants.

For technical drawings and 3-D models, click on a part number.