McMaster-Carr logo
    System of Measurement
    System of Measurement
    Inch
    For Shaft Diameter
    For Shaft Diameter
    1/2"
    5/8"
    3/4"
    1"
    Linear Bearing Component
    Linear Bearing Component
    Bearing
    Bearing Material
    Bearing Material
    Fiberglass
    Bearing Type
    Bearing Type
    Plain
    For Shaft Type
    For Shaft Type
    Round
    For Shaft Material
    For Shaft Material
    Stainless Steel
    Aluminum
    Alignment Style
    Alignment Style
    Fixed Alignment
    For Maximum Housing ID (Inch)
    For Maximum
    Housing ID (Inch)
    0.8755"
    1.1255"
    1.2505"
    1.5630"
    For Minimum Housing ID (Inch)
    For Minimum Housing ID (Inch)
    0.8750"
    1.1250"
    1.2500"
    1.5625"
    For Minimum Stainless Steel Shaft Hardness
    For Minimum Stainless
    Steel Shaft Hardness
    Rockwell B25
    For Shaft Smoothness
    For Shaft Smoothness
    8-16 microns RMS
    Liner Material
    Liner Material
    Plastic
    Lubrication
    Lubrication
    Not Required
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Retaining Ring Groove End-to-End Length
    Retaining Ring Groove
    End-to-End Length
    0.975"
    1.116"
    1.178"
    1.765"
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    Shaft Clearance
    Shaft Clearance
    0.001"
    Static Load Capacity
    Static Load Capacity
    Less than 10,000 lbs.
    10,000 to 19,999 lbs.
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    8 Products