System of Measurement
    System of Measurement
    Inch
    Metric
    For Shaft Diameter
    For Shaft Diameter
    3/8"
    1/2"
    5/8"
    3/4"
    1"
    10mm
    12mm
    16mm
    20mm
    25mm
    Length
    Length
    1"
    2"
    Bearing Type
    Bearing Type
    Plain
    Linear Bearing Component
    Linear Bearing Component
    Bearing in
    Housing
    For Shaft Type
    For Shaft Type
    Round
    Housing Type
    Housing Type
    Base Mount
    Bearing Material
    Bearing Material
    Plastic
    Number of Mounting Holes
    Number of Mounting Holes
    2
    4
    Lubrication
    Lubrication
    Not Required
    Static Load Capacity
    Static Load Capacity
    Less than 10,000 lbs.
    Alignment Style
    Alignment Style
    Fixed Alignment
    Center Height
    Center Height
    9/16"
    11/16"
    7/8"
    15/16"
    1 3/16"
    Mounting Hole Diameter
    Mounting Hole Diameter
    5/16"
    Overall Width
    Overall Width
    3 1/4"
    Minimum Temperature
    Minimum Temperature
    -200° F
    Maximum Temperature
    Maximum Temperature
    Less than 250° F
    Mounting Holes Center-to-Center, Width
    Mounting Holes Center-
    to-Center, Width
    1 5/8"
    Mounting Hole Thread Size
    Mounting Hole Thread Size
    5/16"-18
    With End Seals
    With End Seals
    No
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    20 Products