Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
Bearing Type Bearing Type |
|---|
 | Roller |
For Housing ID For Housing ID |
|---|
|
OD OD |
|---|
|
ID ID |
|---|
|
Seal Type Seal Type |
|---|
|
For Load Direction For Load Direction |
|---|
 | Radial |
Ring Material Ring Material |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Maximum Speed Maximum Speed | Show |
|---|
|
Maximum Speed Maximum Speed | Hide |
|---|
Cage Material Cage Material |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
For Shaft Surface Smoothness (Ra) For Shaft SurfaceSmoothness (Ra) |
|---|
|
Static Radial Load Capacity Static Radial Load Capacity |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Construction Construction |
|---|
|
Roller Material Roller Material |
|---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity |
|---|
|
About Ball and Roller Bearings
More
Needle-Roller Bearings
Also known as drawn-cup roller bearings, these are our thinnest roller bearings. The outer ring is drawn out to form a lip that holds the bearing together. Bearings take on the shape of their housing and may be oblong prior to installation.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Radial Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | For Housing ID | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | For Shaft Surface Smoothness (Ra), microinch | Temp. Range, °F | Each | |
Open | |||||||||||
| 3/8" | 9/16" | 1/2" | Steel | 1,300 | 1,450 | 29,500 | Required | 8 | -40° to 280° | 0000000 | 00000 |
Mounted Roller Bearings with Two-Bolt Flange
These roller bearings handle extremely high speeds for their small size. Use with hardened and ground shafts.
For technical drawings and 3-D models, click on a part number.
Overall | Mounting | Radial Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia. | Ht. | Lg. | Wd. | Flange Thick. | Hole Dia. | Hole Ctr.-to-Ctr. | Dynamic | Static | Max. Speed, rpm | Temp. Range, °F | Lubrication | Each | |
Open Needle-Roller Bearings | |||||||||||||
Fixed Alignment Steel Bearings with Steel Housing—Shaft Mount Type: Slip Fit | |||||||||||||
| 3/8" | 1 1/4" | 1 25/32" | 15/32" | 3/32" | 7/32" | 1 7/32" | 650 | 610 | 29,500 | -20° to 210° | Lubricated | 0000000 | 000000 |