Choose a Category
    Clear All
    System of Measurement
    System of Measurement
    Inch
    Rod End Type
    Rod End Type
    Ball Joint
    Linkage
    Shank Gender
    Shank Gender
    Male
    Maximum Ball Swivel
    Maximum Ball Swivel
    default
    50° or greater
    Shank Thread Direction
    Shank Thread Direction
    Right Hand
    Left Hand
    Ball Stud Thread Direction
    Ball Stud Thread Direction
    Right Hand
    Left Hand
    Ball Stud Thread Size
    Ball Stud Thread Size
    1/4"-28
    5/16"-24
    3/8"-24
    7/16"-20
    1/2"-20
    5/8"-18
    3/4"-16
    10-32
    Lubrication
    Lubrication
    Not Required
    Material
    Material
    Steel
    Ball Stud Center Length
    Ball Stud Center Length
    default
    1 1/64"
    1 1/32"
    1 7/32"
    1 9/16"
    1 3/4"
    2"
    2 1/2"
    3"
    Ball Stud Length
    Ball Stud Length
    default
    1/2"
    9/16"
    11/16"
    29/32"
    1 1/16"
    1 1/8"
    1 1/2"
    1 13/16"
    Shank Thread Length
    Shank Thread Length
    default
    3/4"
    1"
    1 1/4"
    1 3/8"
    1 1/2"
    1 5/8"
    1 3/4"
    Insert Material
    Insert Material
    Steel
    Maximum Temperature
    Maximum Temperature
    325° F
    Minimum Temperature
    Minimum Temperature
    -65° F
    Ball Stud Finish
    Ball Stud Finish
    Chrome Plated
    Liner Material
    Liner Material
    Plastic
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Ball Stud Material
    Ball Stud Material
    Steel
    Finish
    Finish
    Zinc Plated
    Shank Center Length
    Shank Center Length
    default
    1 1/4"
    1 9/16"
    1 7/8"
    1 15/16"
    2 1/8"
    2 7/16"
    2 5/8"
    2 7/8"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    32 Products