Choose a Category
Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
For Housing ID For Housing ID |
|---|
|
OD OD |
|---|
|
ID ID |
|---|
|
Bearing Type Bearing Type |
|---|
 | Ball |
Seal Type Seal Type |
|---|
|
Ball Bearing Type Ball Bearing Type |
|---|
 | Standard |
For Load Direction For Load Direction |
|---|
 | Combined Radial and Thrust |
Trade Number Trade Number | Show |
|---|
|
Trade Number Trade Number | Hide |
|---|
Maximum Speed Maximum Speed |
|---|
|
ABEC Rating ABEC Rating |
|---|
|
Lubrication Lubrication |
|---|
|
Ring Material Ring Material |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Ball Material Ball Material |
|---|
|
Construction Construction |
|---|
|
Contact Angle Contact Angle |
|---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
|---|
|
Lubricant Lubricant |
|---|
|
Maximum Radial Clearance Maximum Radial Clearance |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
About Ball and Roller Bearings
More
Angular-Contact Ball Bearings
Sealed
The raceways in these bearings are positioned off-center to handle angular (combined radial and thrust) loads.
Single-row bearings handle thrust loads on one side. For applications with thrust loads on both sides, mount them in pairs.
Sealed bearings block out dust and other contaminants better than open and shielded bearings, but retain the most heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Trade No. | For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Contact Angle | Temp. Range, °F | ABEC Rating | Specifications Met | Each | |
Single Row | ||||||||||||||
Sealed | ||||||||||||||
| 7202-2RS | 15 | 35 | 11 | Steel | 1,850 | 1,000 | 24,000 | Lubricated | 40° | -20° to 230° | ABEC-1 | DIN 628-1 | 0000000 | 0000000 |
The quick brown fox jumped over the lazy dog. Pedestal (35" Ht. x 4" Wd. x 4" Dp.)