System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
Bearing Type Bearing Type |
---|
![]() | Ball |
Bearing Trade Number Bearing Trade Number | Show |
---|
|
Bearing Trade Number Bearing Trade Number | Hide |
---|
Seal Type Seal Type |
---|
|
For Load Direction For Load Direction |
---|
![]() | Combined Radial and Thrust |
For Housing ID For Housing ID |
---|
|
Ball Bearing Type Ball Bearing Type |
---|
![]() | Standard |
Construction Construction |
---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
---|
|
Ring Material Ring Material |
---|
|
Lubrication Lubrication |
---|
|
OD OD |
---|
|
ID ID |
---|
|
ABEC Rating ABEC Rating |
---|
|
Cage Material Cage Material |
---|
|
Contact Angle Contact Angle |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Lubricant Lubricant |
---|
|
Maximum Radial Clearance Maximum Radial Clearance |
---|
|
Minimum Radial Clearance Minimum Radial Clearance |
---|
|
Seal Material Seal Material |
---|
|
More
Install these bearings for use with combined radial and thrust loads. They are often used in spindle applications and can be combined with cylindrical roller bearings to better handle radial loads.
Single-row bearings handle thrust loads on one side. For applications with thrust loads on both sides, mount them in pairs.
Sealed bearings block out dust and other contaminants better than open and shielded bearings, but retain the most heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Bearing Trade Number | For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Contact Angle | Temp. Range, °F | ABEC Rating | Specifications Met | Each | |
Single Row | ||||||||||||||
Sealed | ||||||||||||||
7203-2RS | 17 | 40 | 12 | Steel | 2,350 | 1,250 | 11,000 | Lubricated | 40° | -20° to 230° | ABEC-1 | DIN 628-1 | 0000000 | 0000000 |