System of Measurement System of Measurement |
---|
|
For Shaft Diameter For Shaft Diameter |
---|
|
For Housing ID For Housing ID |
---|
|
OD OD |
---|
|
ID ID |
---|
|
Bearing Type Bearing Type |
---|
![]() | Ball |
Seal Type Seal Type |
---|
|
Ball Bearing Type Ball Bearing Type |
---|
![]() | ![]() |
Standard | With Retaining Ring |
For Load Direction For Load Direction |
---|
![]() | Radial |
Trade Number Trade Number | Show |
---|
|
Trade Number Trade Number | Hide |
---|
Inner Ring Type Inner Ring Type |
---|
![]() | Extended |
For Shaft Type For Shaft Type |
---|
![]() | Round |
Ring Material Ring Material |
---|
|
Lubrication Lubrication |
---|
|
Shaft Mount Type Shaft Mount Type |
---|
|
Dynamic Radial Load Capacity Dynamic RadialLoad Capacity |
---|
|
Inner Ring OD Inner Ring OD |
---|
|
Inner Ring Width Inner Ring Width |
---|
|
Lubricant Lubricant |
---|
|
Maximum Radial Clearance Maximum Radial Clearance |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Radial Clearance Minimum Radial Clearance |
---|
|
More
With a wider profile than standard ball bearings, these rugged bearings are good for handling heavy loads at low speeds.
Sealed bearings block out dust and other contaminants better than open and shielded bearings, but retain the most heat.
Bearings with extended inner ring provide additional shaft support.
Bearings with retaining ring have a removable retaining ring that holds the bearing inside a housing.
For technical drawings and 3-D models, click on a part number.
Inner Ring | Radial Load Cap., lbs. | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Trade No. | For Shaft Dia. | For Housing ID | Wd. | OD | Wd. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | ABEC Rating | Each | |
7510-2RS | 5/8" | 1 3/4" | 5/8" | 1.009" | 0.75" | Steel | 2,550 | 1,000 | 5,000 | Lubricated | -20° to 250° | Not Rated | 0000000 | 000000 |
Inner Ring | Retaining Ring | Radial Load Cap., lbs. | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Trade No. | For Shaft Dia. | For Housing ID | Wd. | OD | Wd. | OD | Thick. | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | ABEC Rating | Each | |
7510-2RS | 5/8" | 1 3/4" | 5/8" | 1.009" | 0.75" | 1.922" | 0.042" | Steel | 2,550 | 1,000 | 5,000 | Lubricated | -20° to 250° | Not Rated | 0000000 | 000000 |