Clear All
    System of Measurement
    System of Measurement
    Metric
    For Shaft Diameter
    For Shaft Diameter
    16mm
    20mm
    For Shaft Type
    For Shaft Type
    Round with
    Support Rail
    Linear Bearing Component
    Linear Bearing Component
    Bearing
    Bearing Type
    Bearing Type
    Plain
    For Shaft Material
    For Shaft Material
    Stainless Steel
    Steel
    Aluminum
    Bearing Material
    Bearing Material
    Stainless Steel
    Aluminum
    Length
    Length
    36mm
    45mm
    Alignment Style
    Alignment Style
    Self Aligning
    Fixed Alignment
    Liner Material
    Liner Material
    Plastic
    Ceramic
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Minimum Stainless Steel Shaft Hardness
    For Minimum Stainless
    Steel Shaft Hardness
    Rockwell B25
    Rockwell C60
    For Shaft Smoothness
    For Shaft Smoothness
    8-16 microns RMS
    Lubrication
    Lubrication
    Required
    Not Required
    Maximum Temperature
    Maximum Temperature
    250° to 499° F
    Minimum Temperature
    Minimum Temperature
    -250° F or less
    Retaining Ring Groove End-to-End Length
    Retaining Ring Groove
    End-to-End Length
    24.6mm
    28mm
    31.2mm
    Shaft Clearance
    Shaft Clearance
    0.001"
    0.05 mm
    Static Load Capacity
    Static Load Capacity
    Less than 10,000 lbs.
    With End Seals
    With End Seals
    No
    Width
    Width
    Show
    10.8mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    11 Products