Clear All
    System of Measurement
    System of Measurement
    Metric
    For Shaft Diameter
    For Shaft Diameter
    25mm
    For Shaft Type
    For Shaft Type
    Round with
    Support Rail
    Bearing Type
    Bearing Type
    Plain
    Linear Bearing Component
    Linear Bearing Component
    Bearing
    OD
    OD
    40mm
    For Shaft Material
    For Shaft Material
    Stainless Steel
    Steel
    Aluminum
    Alignment Style
    Alignment Style
    Self Aligning
    Fixed Alignment
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    For Shaft Smoothness
    For Shaft Smoothness
    8-16 microns RMS
    Retaining Ring Groove End-to-End Length
    Retaining Ring Groove
    End-to-End Length
    40mm
    43.7mm
    Shaft Clearance
    Shaft Clearance
    0.001"
    0.05 mm
    With End Seals
    With End Seals
    No
    With Retaining Ring Grooves
    With Retaining Ring Grooves
    Yes
    Dynamic Load Capacity
    Dynamic Load Capacity
    200 lbs. @ 100 fpm
    500 lbs. @ 100 fpm
    600 lbs. @ 100 fpm
    For Minimum Stainless Steel Shaft Hardness
    For Minimum Stainless
    Steel Shaft Hardness
    Rockwell B25
    Rockwell C60
    Lubrication
    Lubrication
    Required
    Not Required
    Maximum Temperature
    Maximum Temperature
    250° to 499° F
    Minimum Temperature
    Minimum Temperature
    -250° F or less
    Static Load Capacity
    Static Load Capacity
    Less than 10,000 lbs.
    Liner Material
    Liner Material
    Plastic
    Ceramic
    Width
    Width
    Show
    13.2mm
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    6 Products