Switches have a digital display for easy monitoring at the source of your application.

Prevent changes to the set pressure that activates equipment—these switches come ready to use at your preferred setpoint.

Use in high-temperature applications up to 300° F.

Switches have a digital display for easy monitoring at the source of your application.

Use in medium-pressure applications up to 540 psi.

Use in low-pressure applications up to 90 psi.

Built with an explosionproof enclosure to meet NEMA 7 and 9 standards for hazardous locations, these switches were tested and verified by UL and CSA for use where explosive liquids, dust, and gas are present.

Cleaned to ASTM G93 requirements and then bagged, these switches meet the strict cleaning standards required for oxygen service lines.

Choose when these switches reset to control the pressure range between when they activate and deactivate, commonly referred to as deadband and differential.

When these switches reach a set pressure, they send electronic signals to your programmable logic controller (PLC) to activate automated controls or alarms.

These switches operate based on the difference in pressure between two process lines. When the differential pressure exceeds your setpoint, the switch is activated.

Not only are these switches rated NEMA 4X for protection from dirt, washdowns, and corrosion, they also have an indicator for additional monitoring at the source of your application.