These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

Use these indicators near magnetic chucks and other equipment with a magnetic field. Sets include a contact point adapter, swivel clamp, hole attachment, and mounting accessories.

The contact point is located on the back of this indicator, which allows the dial face to be read from above. It has a continuous dial numbered clockwise around the face for direct measurements.

For comparative measurements of a part's tolerance against a reference measurement, these Starrett indicators have a balanced dial with positive values on one side and negative values on the other side.

For direct measurements, these Starrett indicators have a continuous dial numbered clockwise around the face.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

For comparative measurements of a part's tolerance against a reference measurement, these indicators have a balanced dial with positive values on one side and negative values on the other side.

Take direct and comparative measurements with the same indicator. The combination dial has both a continuous scale numbered clockwise around the face and a balanced scale with positive values on one side of the zero and negative values on the other side.

Place the magnetic base on metal surfaces for a solid mount. The base has a V-grooved bottom for mounting on flat and curved surfaces and magnetic release switch for easy setups.

These indicators have a larger display than other Mitutoyo electronic indicators for easier reading.

A slim design fits in tight spots. These indicators have a spring-loaded plunger that retracts and extends to measure objects.

Read measurements on an LCD. These Mitutoyo indicators have a spring-loaded plunger that retracts and extends to measure objects.

For use in wet environments, these indicators are IP53 rated for limited protection from dust and spraying water. A spring-loaded plunger retracts and extends to measure objects.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

These indicators come with a calibration certificate traceable to NIST that states they’ve passed a test for accuracy.

Read measurements on an LCD. These Starrett indicators have a spring-loaded plunger that retracts and extends to measure objects.

Sets include attachments for indicator mounting.

Place the magnetic base on metal surfaces for a solid mount.

Mount one of these rods between the plunger and contact point to extend the reach of your indicator.

Remove the spindle cap on your Mitutoyo indicator and install a lever for easier lifting of the indicator spindle.

Measure internal surfaces that standard contact points can’t reach. These adapters transfer the up and down motion of the contact point 90° to a second contact point that moves left to right.

Use with swivel clamps to position indicators.