Drill a pilot hole, cut threads, and fasten in one motion with these metric-threaded screws. Made of steel, they’re strong and wear resistant.

Cutting wings under the head allow plastic to expand and contract without cracking. A washer made from aluminum and rubber bonded to steel adds a watertight seal.

These steel screws are zinc plated to resist corrosion in wet environments.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

Beveled under the head for use in countersunk holes, these steel screws press threads into material for a tight, secure hold.

These steel screws are zinc plated to resist corrosion in wet environments.

18-8 stainless steel screws have good chemical resistance.

18-8 stainless steel screws have good chemical resistance.

A decorative rounded top provides a finished appearance. These Phillips screws are beveled under the head for use in countersunk holes. They press threads into material for a tight, secure hold.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

Drive the pointed tip of these screws into soft material, such as wood and drywall. They are also known as lag bolts.

These steel screws are zinc plated to resist corrosion in wet environments.

18-8 stainless steel screws have good chemical resistance.

These 316 stainless steel screws have excellent resistance to chemicals and salt water.

These screws speed installation by drilling, tapping, and fastening wood and metal in a single operation.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

Also known as Type 17 auger point screws, these penetrate hardwood and reduce driving torque. They require a pilot hole to prevent splitting when used near an edge.

More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.

18-8 stainless steel screws have good chemical resistance.

Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.

The neoprene-backed washer seals out contaminants.

Often used for drawer slides and cabinet hardware, these screws—also known as Euro and Type B screws—create a strong hold in small, shallow holes in wood.

Ribs under the head act as a brake to prevent over-tightening and damaging threads.

Drill holes with the point on these hangers.

A wing-like toggle holds against the back of the material and spreads the force over a large area to hold 30 lbs. or more.

Kits include a hand punch tool with die and six complete snaps with tapping screw studs.