These steel anchors are available with corrosion-resistant finishes.

These 18-8 stainless steel anchors have good chemical resistance.

A zinc plating provides corrosion resistance in wet environments.

The removable flat head provides a flush finish in countersunk holes.

A zinc plating provides corrosion resistance in wet environments.

A zinc plating provides corrosion resistance in wet environments.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

The fastest way to install shallow-hole female-threaded anchors. Just push the tip of the tool into the anchor and turn the tool with a power drill.

Also known as caulk-in anchors, these stay secure when there's not much material to hold.

Also known as drive rivets, install these anchors by hammering the pin into the body. Pry out the pin to remove.

Also known as drive rivets, install by hammering the screw into the body. Unthread the screw to remove.

Use in applications requiring high strength.

Also known as tap-in or uni-tap rivets, these anchors are barbed to resist pull out. Made from nylon, they're chemical resistant.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

A hex head allows for a secure grip with a wrench.

These steel anchors are available with corrosion-resistant finishes.

These steel anchors are available with corrosion-resistant finishes.

These stud-style anchors include a nut and a washer.

A pivoting toggle bar creates a strong hold.

A spring-loaded toggle holds against the back of the material.

A shallow head makes these bolts good for low-clearance applications.

High-strength toggle anchors provide an extremely strong hold and stay in position when a bolt is removed.

Fins prevent these anchors from spinning during installation.

Use these stud-style anchors with nuts.

Also known as Tapcons, use these screws in applications requiring high strength.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

A wing-like toggle holds against the back of the material and spreads the force over a large area to hold 30 lbs. or more.

Permanently set threaded rods, studs, and rebar in concrete.

These kits include adhesives, applicators, and mixer nozzles.