These steel anchors are available with corrosion-resistant finishes.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

A zinc plating provides corrosion resistance in wet environments.

The removable flat head provides a flush finish in countersunk holes.

Also known as caulk-in anchors, these stay secure when there's not much material to hold.

An adjustable stop allows you to set anchors at consistent depths. Use with a hammer.

Often referred to as four-way expansion anchors, these expand in four directions to resist loosening from vibration.

A zinc plating provides corrosion resistance in wet environments.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

These 18-8 stainless steel anchors have good chemical resistance.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

Also known as drive rivets, install these anchors by hammering the pin into the body. Pry out the pin to remove.

Also known as drive rivets, install by hammering the screw into the body. Unthread the screw to remove.

Use in applications requiring high strength.

A zinc plating provides corrosion resistance in wet environments.

A hex head allows for a secure grip with a wrench.

For narrow holes and small cavities where toggle anchors won't fit.

Also known as Tapcons, use these screws in applications requiring high strength.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

Use these bits with handheld power drills, drill presses, and hammer drills.

Drive a tapping screw without removing the drill bit from your impact driver. One end holds an insert or nutdriver bit, while the other end engages with the hex-collar on the drill bit.

For tough jobs, these adhesives are 20% stronger than our standard concrete-anchoring adhesives.

Permanently set threaded rods, studs, and rebar in concrete.