Choose a Category
    Clear All
    Countersink Angle
    Countersink Angle
    About Countersink Angle
    default
    82°
    90°
    Number of Flutes
    Number of Flutes
    4
    System of Measurement
    System of Measurement
    Inch
    Body Diameter
    Body Diameter
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    5/8"
    3/4"
    Material
    Material
    Carbide
    Shank Diameter
    Shank Diameter
    1/8"
    3/16"
    1/4"
    5/16"
    3/8"
    1/2"
    5/8"
    3/4"
    Overall Length
    Overall Length
    1 1/2"
    2"
    2 1/2"
    3"
    3 1/2"
    4"
    Number of Countersinking Ends
    Number of
    Countersinking Ends
    2
    Shank Material
    Shank Material
    Carbide
    Drill Tip Diameter
    Drill Tip Diameter
    0.041"
    0.062"
    0.082"
    0.104"
    0.125"
    0.167"
    0.208"
    0.250"
    Individual/Set
    Individual/Set
    Individual
    Shank Type
    Shank Type
    Round
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Finish
    Finish
    Uncoated
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    16 Products

    Carbide Starter-Hole-Eliminating Drill-Point
    Countersinks with Two Countersinking Ends for Screws

    Dia.
    BodyShankDrill TipOverall
    Lg.For Use On Each
    82° Countersink Angle
    Uncoated Carbide
    4 Flute
    90° Countersink Angle
    Uncoated Carbide
    4 Flute