Choose a Category
    Clear All
    System of Measurement
    System of Measurement
    Inch
    For Use On
    For Use On
    Ceramic
    Concrete
    Glass
    Masonry
    Material
    Material
    Carbide
    Steel
    Shank Type
    Shank Type
    SDS Max
    Spline
    Point Style
    Point Style
    Standard
    Point Angle
    Point Angle
    120°
    Bit Style
    Bit Style
    Hollow
    Individual/Set
    Individual/Set
    Individual
    Overall Length
    Overall Length
    3 1/2"
    17"
    Flute Direction
    Flute Direction
    Right Hand
    Maximum Drilling Depth
    Maximum Drilling Depth
    2"
    12"
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Specifications Met
    Specifications Met
    Component
    Component
    Show
    Core Drill Bit
    Diamond Tip Length
    Diamond Tip Length
    1/8"
    1/4"
    Maximum Recommended Operating Speed
    Maximum Recommended
    Operating Speed
    1,800 rpm
    2,400 rpm
    Minimum Recommended Operating Speed
    Minimum Recommended
    Operating Speed
    1,250 rpm
    1,800 rpm
    For Drilling Type
    For Drilling Type
    Hammer and Rotary
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    48 Products

    Changeable-Size SDS-Max-Shank Masonry Core Drill Bits for Rotary Hammers

    Inch Drill Bits

    Changeable-Size Spline-Shank Masonry Core Drill Bits for Rotary Hammers

    Inch Drill Bits
    Bit Bodies
    Replacement Pilot Drills
    Length Extensions

    Core Drill Bits for Glass and Ceramic

    Inch Drill Bits