These jobbers'-length bits have the rigidity and length required for most applications.

These jobbers'-length bits have the rigidity and length required for most applications.

These jobbers'-length bits have the rigidity and length required for most applications.

Three cutting edges instead of the typical two enable these bits to drill holes with a smoother finish than other bits.

Harder, stronger, and more wear resistant than carbide-tipped steel, solid-carbide bits maintain their sharp edges longer. They require rigid toolholding to prevent breakage and should not be used in hand-held drilling applications.

Because softer metal, like aluminum, brass, and bronze, can clog a bit, the flutes on these bits lift chips out of the hole. Also known as slow-spiral drill bits.

Three drill points allow these bits to separate spot-welded panels without damaging the bottom panel.

No need to create a starter hole—the drill point is incorporated into the countersink flutes.

For excellent performance on hard and abrasive materials, these carbide countersinks are harder, stronger, and more wear resistant than cobalt steel and high-speed steel countersinks.

Carbide is harder, stronger, and more wear resistant than high-speed steel for excellent performance on hard and abrasive materials.

The same tool lets you drill and counterbore holes with enough clearance for socket head screws.

Keep counterbores in various sizes on hand to drill and counterbore holes with enough clearance for socket head cap screws without changing tools.

The small-diameter shaft can access screws in narrow recessed holes.

Strong and durable, these multipurpose bits are for use with bit screwdrivers. They are often used with power tools to install sheet metal screws.

The small-diameter shaft can access screws in narrow recessed holes.

Bits have a different size at each end.

Turn two drive styles with one reversible bit. Remove and replace to change the tip.

Attach these adapters to square-drive tools.

Insert these taps directly into drills, power screwdrivers, and other tools that accept a 1/4" hex shank.

Also known as reamer blanks, these rods are hardened for increased abrasion and impact resistance.

An oversized diameter allows for finishing to your exact requirements.

An oversized diameter allows for finishing to your exact requirements.

Furnished hardened, P20 tool steel is strong and easy to machine. It has the wear resistance and highly polishable surface needed to fabricate long-lasting molds and dies.