These jobbers'-length bits have the rigidity and length required for most applications. Made of cobalt steel, which has better heat and wear resistance than high-speed steel, they can run up to 25% faster and have a longer tool life.

Titanium-nitride (TiN) coated drill bits last longer and can drill at higher speeds than uncoated drill bits.

Drill bits with a split point keep centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

Holes in these bits allow coolant to be run through the tool for more efficient chip evacuation. Use them in CNC machines with coolant-through technology. Made of solid carbide for the highest accuracy and longest tool life, they are harder, stronger, and more wear resistant than high-speed steel, cobalt steel, and carbide-tipped bits. They retain a sharp, hard edge at high temperatures for the best performance on hard and abrasive material. A titanium aluminum nitride (TiAlN) coating gives them additional wear and temperature resistance. The four-facet point keeps the bit centered without a pilot hole. These bits require rigid toolholding to prevent breakage and should not be used in hand-held drilling applications.

Jobbers'-length drill bits have the rigidity and length required for most applications.

For technical drawings and 3-D models, click on a part number.

The shank has a smaller diameter than the tip, allowing you to drill large holes with machines that have small-capacity chucks. A split point keeps the bit centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

These bits are cut to match a wood screw’s thread and diameter, resulting in a perfect fit for a screw. They produce clean edges when cutting soft and hard wood.

For technical drawings and 3-D models, click on a part number.

The sharp point allows for gradual penetration to reduce friction and eliminate cracking and chipping when drilling in plastic. These bits are jobbers' length and have the rigidity and length required for most applications.

For technical drawings and 3-D models, click on a part number.

Because softer metal, like aluminum, brass, and bronze, can clog a bit, the flutes on these bits lift chips out of the hole. Also known as slow-spiral drill bits. They are jobbers' length and have the rigidity and length required for most applications.

For technical drawings and 3-D models, click on a part number.

A ratchet mechanism allows you to drive fasteners when there's little space to move the handle.

Style C accept two shank sizes and have offset heads to access screws in obstructed areas. Magnets hold the bits.

Drill and thread holes for pipe and conduit without switching tools. Made of uncoated high-speed steel, these tools are for use on most metal and plastic. Their right-hand spiral flutes keep chips clear by drawing them back toward the tap and out of the hole. With a square shank, they're compatible with tap wrenches and tap holders for drill presses and milling machines. All have a plug chamfer with 3-5 chamfered cutting threads, so they're suitable for start-to-finish tapping of through holes.

These rods, also known as drill blanks, have an undersized diameter for machining your own jobbers'-length drill bits. They're hardened for increased abrasion and impact resistance. M2 tool steel offers a nice balance of wear resistance and machinability. It has a high molybdenum content, which allows it to maintain sharp cutting edges even at elevated temperatures.

For technical drawings and 3-D models, click on a part number.

Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.