Drill bits with a split point keep centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

These jobbers'-length bits have the rigidity and length required for most applications. Made of carbide-tipped steel, which has better wear resistance than high-speed steel and cobalt steel, they maintain a sharper, harder edge at high temperatures for excellent performance on abrasive material, such as plastic. Because they aren’t as brittle as solid carbide bits, they can be used in less rigid setups, such as a hand-held drill.

Drill bits with a split point keep centered without a pilot hole.

Drill bits with 135° point angle produce smaller chips than 118° point to prevent clogging.

For technical drawings and 3-D models, click on a part number.

The shank has a smaller diameter than the tip, allowing you to drill large holes with machines that have small-capacity chucks. Also known as Silver and Deming bits, they have a 1/2” diameter shank.

Drill bits with flats on shank have three flat sides to prevent the bit from slipping in the drill chuck.

Drill bits with a split point keep centered without a pilot hole.

For technical drawings and 3-D models, click on a part number.

With better heat and wear resistance than high-speed steel, these cobalt steel bits can run up to 25% faster and have a longer tool life. The shank has a smaller diameter than the tip, allowing you to drill large holes with machines that have small-capacity chucks. A split point keeps the bit centered without a pilot hole. Also known as Silver and Deming bits, they have a 1/2” diameter shank.