These assorted keys have a ball end that allows angled entry to make good contact with the screw recess when standard-tip keys can’t. Use to turn screws in hard-to-reach spots.

The extra-short leg of these keys fits in tight spaces other tools can't and the long-leg ball end allows angled entry to turn screws in hard-to-reach areas.

All of the keys in these sets have an extra-short leg to fit into tight spots and a ball end to turn screws at an angle in hard-to-reach places. Their bright chrome-plated finish makes them easy to see, reducing the chance you’ll lose them.

These keys have an extra-short leg to fit into tight spaces that other tools can’t, and a ball on the long leg for angled entry to turn screws in hard-to-reach places. A bright chrome-plated finish makes them easy to see and less likely to be misplaced.

The ball end has a detent to grip inside the screw recess and allows angled entry to turn fasteners in hard-to-reach areas.

Sets include assorted keys with each size a different color for easy identification. When a standard-tip key can't make good contact with the recess, a ball end allows angled entry to turn screws in hard-to-reach places.

Sets include an assortment of stainless steel keys with a ball end that allows angled entry to turn screws in hard-to-reach areas. Use a stainless steel L-key to protect your stainless steel screws. If steel flakes off a standard tool and into the recess, it can lead to rust and contamination. These keys eliminate that risk.

Often used to install carbide inserts in cutting tools, these keys have a small handle that prevents you from generating too much torque when turning a fastener.

These assorted keys have a ball-end tip with a retaining ring that grips inside the recess to hold screws in place and allows angled entry to turn fasteners in hard-to-reach areas.

A holding mechanism at the tip of the tool ensures the screw won’t slip off.

The shaft and handle are drilled all the way through for turning nuts on any length of threaded rod. These drivers have a magnet in the tip to hold nuts in place.

A magnet in the tip holds nuts in place.

Because they make contact on the flat sides of fasteners rather than only on the corners, these magnetic bits significantly reduce slipping and stripping. They’re also known as lobular bits.

A magnet holds the nut in place.