Fasten hard-to-bond plastics, such as polypropylene and polyethylene.

Mixed with rubber for better impact resistance than standard instant-bond adhesives, these adhesives form strong, resilient bonds.

To invisibly bond transparent plastics, these adhesives won’t turn cloudy.

In especially damp or humid environments, these adhesives keep their hold.

Form bonds without the strong odor of other instant-bond adhesives.

Bond plastics, porous materials, or dirty surfaces.

These super glues are blended with rubber for better impact and moisture resistance than other instant-bond adhesives.

These thin liquids, also known as super glue, flow into small gaps.

To invisibly bond transparent plastics, these adhesives won’t turn cloudy.

For easy positioning, these adhesives begin to harden only when exposed to light.

Moisture, humidity, and immersion in water won't degrade the bond of these adhesives.

Toughened adhesives are blended with rubber particles for better impact resistance than standard epoxies. They form flexible, resilient bonds.

Even when used under water, these adhesives maintain their strength.

To allow time to adjust and position parts, these epoxies remain workable for at least 90 minutes.

Fasten hard-to-bond plastics, such as polypropylene and polyethylene, with these epoxies.

These machinable epoxies are mixed with metal so they can be used to repair cracks and threaded holes.

Bond most materials without the strong odor of other epoxy adhesives.

No need to mix these acrylics—apply adhesive to one surface and activator to the other, then bring surfaces together to bond.

Toughened adhesives are blended with rubber particles for better impact resistance than standard acrylics. They form resilient bonds.

Solvents, oils, acids, and other chemicals won't degrade the bond of these adhesives.

With high shear strength and peel strength, these form the strongest bonds of our urethane adhesives.

When heated, these glue sticks melt and quickly begin to harden. Use them to seal packaging and form other low- to medium-strength bonds.

Glue hardens in 15 seconds or less to bond quickly.

In addition to being waterproof, this glue is made of FDA listed materials.

Also known as Gorilla Glue, this glue expands to form stronger bonds than other glue.

The 3M VHB adhesive on these rolls offers a strong hold that can replace rivets, spot welds, and other permanent fasteners.

Use these glue rolls with 3M dispensing guns.

Temporarily stabilize objects on flat surfaces with this clear, reusable adhesive.

This putty-like glue cures into a pliable rubber. Use it to repair seals and cracks, or mold it into hooks and bumpers.

This glue withstands temperatures up to 500° F.

Form bonds with twice the strength of our other spray adhesives.

Splice rubber O-rings and other gaskets with this chemical resistant adhesive.

These spray glues adhere quickly.

Bonds reach full strength in 10 minutes.

These adhesives resist temperatures up to 500° F.

Form strong bonds on most plastics.

Because this cement won't break down when exposed to corrosive waste, it's often used on plastic pipe fittings in laboratories.

Rubber cement allows repositioning until fully dried. Use it on paper and cardboard.

Install building materials such as wood and drywall with these general purpose adhesives.

Bond carpeting, vinyl tile, and other floor coverings to subfloors.

Bond and repair nosing and stair treads with this thick, two-part epoxy.

Adhere vinyl and rubber wall bases to wood, drywall, and concrete.

Tack wires to coil forms or secure and insulate hardware on printed circuit boards. These adhesives require an accelerator.

Bond new concrete to old concrete, or use this adhesive as a primer on concrete surfaces.

These kits include adhesives, applicators, and mixer nozzles.

Only for use with 3M dual cartridges, these guns dispense two-part adhesives.

Use these guns to dispense two-part adhesives. Do not use them with 3M dual cartridges.