Because this cement won't break down when exposed to corrosive waste, it's often used on plastic pipe fittings in laboratories.

Prevent threaded fasteners from loosening due to shock and vibration.

Use these threadlockers on fasteners that require occasional fine-tuning, such as set screws.

Apply these threadlockers on fasteners that are already installed—their thin consistency allows them to flow into small gaps.

Fill gaps up to 0.01" to secure unthreaded cylindrical metal parts such as shafts, bearings, and press-fit assemblies.

Resistant to mold and mildew, these sealants are well suited to high-humidity environments.

A combination of hardness and surface tension makes these sealants resistant to punctures, cuts, and abrasion.

These structural sealants combine the mechanical strength of an adhesive with excellent sealing properties and high flexibility.

Also known as neutral cure, this sealant won't discolor copper, brass, plastic, and concrete.

Mix a small amount of water-based paint with this caulk to match the color of your surface.

Formulated for high lubricity, these sealants allow easy assembly of finely threaded hydraulic and compressed air system components. They're also free of fillers that could contaminate system media.

Make seals that support glass under heavy loads in equipment and buildings.

Thinner than non-sag sealants, these flow easily into cracks and have a smooth finish.

These non-sagging sealants will not drip while hardening on vertical and overhead surfaces.

Seal joints and gaps in concrete.