McMaster-Carr logo
    Clear All
    Shank Type
    Shank Type
    Morse TaperRound
    Square
    Material
    Material
    Show
    High-Speed Steel
    For Use With
    For Use With
    Drill Presses
    Milling Machines
    System of Measurement
    System of Measurement
    Inch
    Shank Width
    Shank Width
    1/4"
    5/16"
    3/8"
    For Cutter Material
    For Cutter Material
    Cobalt Steel
    High-Speed Steel
    Cut Direction
    Cut Direction
    Right HandLeft Hand
    Neutral
    Morse Taper Number
    Morse Taper Number
    2
    3
    Shank Diameter
    Shank Diameter
    3/4"
    Shank Height
    Shank Height
    1/4"
    5/16"
    3/8"
    Morse Taper Diameter
    Morse Taper Diameter
    0.7"
    0.938"
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    For Holding
    For Holding
    Annular Cutters
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    click to learn more about
    Back Rake Angle
    Back Rake Angle
    default
    -15°
    -12°
    -8°
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    28°
    32°
    45°
    End Relief Angle
    End Relief Angle
    default
    18°
    20°
    22°
    28°
    Side Relief Angle
    Side Relief Angle
    default
    10°
    15°
    19°
    22°
    Side Rake Angle
    Side Rake Angle
    default
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    36 Products