46 Products

Customize these dispensers to serve up to 24 lubrication points from a single location. Dispensers come with two flow-adjustment valves and can accommodate up to 24 valves total. Additional valves are sold separately. Valves thread together to make a sealed connection. Adjust the flow to individual lubrication points by turning the dial on the corresponding valve. Flip the lever to start and stop flow to all of the valves at once.

Serve multiple lubrication points from a single location. These dispensers have a solenoid that automatically starts and stops flow so lubrication is dispensed only while equipment is running. When wired to a machine’s on/off switch, the solenoid remains closed until the machine is turned on. To adjust the flow to individual lubrication points, turn the dial on the corresponding valve. Dispensers can be used with any oil grade. Flow rate depends on temperature.

Mount these reservoirs directly to your machine, or use them with a flow-adjustment valve and brush (each sold separately) to create a dispenser.

Reservoirs with 140° F max. temp. have NPTF (Dryseal) threads, which are compatible with NPT threads. Flow rate depends on temperature.

Reservoirs with removable filter prevent valve blockage.

For use in clean environments, these oil reservoirs have multiple air vents that keep pressure balanced. They maintain a constant level of oil in bearing housings, gear boxes, and similar closed machinery. When oil falls below the set level, these reservoirs automatically replenish the supply. They have oil outlets on the side and bottom for flexibility in installation. For applications that require adjustable flow control, pair with a flow-adjustment valve (sold separately).

A sealed design prevents contamination in dirty and dusty environments. Install a line between the reservoir's pressure port and the lubricated equipment to balance pressure. Designed to maintain a constant level of oil in bearing housings, gear boxes, and similar closed machinery, when oil falls below the set level, these reservoirs automatically replenish the supply. They have oil outlets on the side and bottom for flexibility in installation. For applications that require adjustable flow control, pair with a flow-adjustment valve (sold separately).

Flip the lever to start and stop the flow of oil through the brush; turn the dial to adjust flow. Dispensers can be used with any oil grade. Flow rate depends on temperature.

A solenoid automatically starts and stops flow so lubrication is dispensed only while equipment is running. When wired to a machine’s on/off switch, the solenoid remains closed until the machine is turned on. Turn the dial on the valve to adjust the flow of oil through the brush. Dispensers can be used with any oil grade. Flow rate depends on temperature.

Charge these accumulators to the pressure you need, and they will help a system maintain a constant pressure during pump failure. Mount them in any orientation. UN/UNF (SAE) thread connections have straight threads and are also known as O-ring Boss fittings.

Note: For safety, do not disassemble accumulators while they're under pressure.

Use a charging and gauging kit to increase or decrease an accumulator’s charge.

For technical drawings and 3-D models, click on a part number.

These accumulators come with a charge of nitrogen and are ready to use. They help a system maintain a constant pressure during pump failure. Mount these accumulators in any orientation. UN/UNF (SAE) thread connections have straight threads and are also known as O-ring Boss fittings.

Note: For safety, do not disassemble accumulators while they're under pressure.

Use a charging and gauging kit to increase or decrease an accumulator’s charge.

For technical drawings and 3-D models, click on a part number.

Charge these accumulators to the pressure you need, and they will help a system maintain a constant pressure during pump failure. Mount accumulators within 25° of vertical. UN/UNF (SAE) thread connections have straight threads and are also known as O-ring Boss fittings.

Note: For safety, do not disassemble accumulators while they're under pressure.

Use a charging and gauging kit to increase or decrease an accumulator's charge.

For technical drawings and 3-D models, click on a part number.