These general purpose lubricants reduce friction between your cutting tool and workpiece to make cutting cycles faster and easier, improve surface finishes, and extend tool life.

A high sulfur concentration provides the lubricity required to protect tools and stainless steel work surfaces, but these lubricants will stain other metal. They reduce friction between your cutting tool and workpiece to make cutting cycles faster and easier.

Use these lubricants for easier and faster tapping, cutting, and threading of hard and thick material. They reduce friction between your cutting tool and workpiece to make cutting cycles faster and easier, improve surface finishes, and extend tool life.

Apply this oil to sheet metal before stamping or drawing to extend die life. It quickly evaporates, leaving behind a thin, easy-to-clean film.

An alternative to nearly dry machining, apply these coolants to tools before milling and machining to reduce heat with minimal cleanup. They’re often used for shallow drilling, reaming, and tapping, as well as on saw blades.

Apply just a few drops of these coolants to your cutting tools before and during milling and machining to reduce heat with very little cleanup.

Remove heat from long machining cycles with hard metal. These coolants prevent workpiece corrosion and distortion to improve cutting accuracy.

Increase the time between coolant changes—wear-resistant properties allow these coolants to perform longer than standard grinding coolants. They prevent material from building up to ensure a high-quality finish and preserve tool life.

Use these coolants in drawing, stamping, and forming applications with all metal. They protect both dies and cutting edges as well as finished workpieces.

Weld longer without damaging your torch—replace the water in your welding cooler with these coolants to prevent mineral deposits and frozen lines. Coolants also tolerate colder temperatures than water. For use with MIG, TIG, spot, and stud welders. They are nonconductive.

Made with graphite and nickel, these lubricants can be used in environments with extreme heat and harsh chemicals where antiseize lubricants with copper can't. Also known as thread lubricants, antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

Corrosion-resistant additives allow these lubricants to prevent parts from locking together in caustic environments, such as steel mills and power plants.

Often used with engine bolts and heavily-loaded, slow-moving gears, these lubricants are formulated with moly (molybdenum disulfide) to prevent parts from locking together under high loads and pressure.

Copper allows these lubricants to conduct electricity, while graphite gives them good chemical and corrosion resistance. Use them to prevent threaded fasteners and close-fitting parts from locking together in connections where you need to conduct electricity.

Use these lubricants to prevent threaded fasteners and close-fitting parts in food-processing and preparation areas from locking together. They're NSF registered H1 for incidental food contact.

For hoses and other tight-fitting parts, apply these lubricants to rubber or plastic before assembling and disassembling. After drying, they lose their lubricity, so parts stay together. They leave no residue on assembled parts.