Use these vises for reliable workholding on CNC machines.

Hardened for wear resistance, these steel jaws are replacements for the ones that come installed on your vise.

The V-shaped recess holds round material securely for machining.

Quickly move parallels in and out of these jaws to raise your workpiece within the vise. Mount jaws to the vise, slide the mating parallels in place, and rest your workpiece on top.

The vise body and stationary jaw are one piece for high repeatability, even under heavy clamping loads. Ground flat on the base and three sides, these vises ensure accuracy whether mounted on the base, either side, or upright.

Replace worn, broken, or lost handles.

Store vise handles near your milling machine.

Designed to hold your part on 4- and 5-axis milling machines, these vises provide rigid clamping while exposing five full sides of the workpiece. This allows even complex parts to be completed in a single operation. You must cut a dovetail into your material before the vise can grip it.

Turn the handle to move the jaw on these basic vises.

The base and three sides of the vise are ground flat, enabling mounting on its base, either side, or upright.

The dials on these vises are graduated in smaller increments than standard cross-slide drill-press vises for finer adjustment. Use to precisely position work on X and Y axes.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Tilt the head on two axes and rotate the base to position your workpiece at almost any angle.

Keep parts in position for machining by mounting these workstops to your vise jaws.

The T-nut base secures the workstop into the slots of a machine table for positioning parts that extend beyond the jaws of your vise.

Sets include multiple sizes of matched pairs that are precision ground for tight tolerances on the top and bottom edges.

Instead of keeping an assortment of parallels on hand, adjust these two-piece tools to your exact height requirements.