These Class 10.9 steel threaded rods are about 25% stronger than medium-strength steel rods.

These metric Grade B7 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

An economical alternative to Grade B7 and Grade B16 threaded rods, these metric Class 8.8 rods are suitable for fastening most machinery and equipment.

About half the strength of medium-strength steel threaded rods, use these metric fine-thread rods for light duty hanging, mounting, and fastening.

Available in metric sizes, these 18-8 stainless steel threaded rods have good chemical resistance.

These metric threaded rods are made from nylon 6/6 and resist oil, grease, and solvents. They’re nonconductive, making them good for use around sensitive electrical components.

Screw the threaded end of these metric studs into a tapped hole and use the unthreaded end as a pivot point, hinge, shaft, or locator pin.

18-8 stainless steel studs have good chemical resistance.

316 stainless steel studs have excellent resistance to chemicals and salt water.

For light duty applications, choose these metric-sized coupling nuts.

These metric-sized coupling nuts are Class 10 steel, so they’re about 25% stronger than medium-strength steel coupling nuts.

More corrosion resistant than 18-8 stainless steel coupling nuts, these metric nuts have excellent resistance to chemicals and salt water.

Increase or decrease metric thread size from one male-threaded part to another. Commonly used to connect two differently sized threaded rods, they have a hex-shaped body, so you can tighten them with a standard wrench.

These metric lead screws and nuts have broad, square threads that are well suited for quick assembly, high clamping forces, and lifting and lowering heavy objects. They're commonly found in hand-powered clamps, vises, grates, doors, and work tables.

Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.

Internal ball bearings provide smooth low-friction travel in applications that require high speeds, accurate positioning, and repeatable movement. Also known as single-start metric ball screws and nuts, these have a single thread that runs the length of the screw.

With multiple thread starts, these metric ball screws create linear travel that’s approximately three times faster than ball screws with a single thread start. They’re ideal for applications with an actuator.

Install these threaded collars on a metric lead screw to separate and position components, or use them as an end stop to limit travel.

Combine these setup studs with T-slot nuts, flanged nuts, setup clamps, or setup blocks to clamp and hold workpieces, vises, and other objects onto your fixturing table. Also known as double-ended studs, they have threads on both ends.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Attach threaded accessories, such as mixer propellers and fan blades, to the end of these shafts.