This material has tighter tolerances than standard 303 stainless steel.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

Precision ground on the top and bottom to a tight tolerance.

Precision ground to a tight diameter tolerance, these rods are all set for turning applications in a lathe.

Hardened for improved strength and wear resistance, these rods are precision ground to a strict diameter tolerance. Use them for turning applications in your lathe.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.