We will reply to your message within an hour.
More
Pins on either side of the base lock these bulbs into sockets.
Bulbs have two filaments, which operate at different brightness levels.
These bulbs are sized to fit tight spaces such as indicators and vehicle lights.
These bulbs are sized to fit tight spaces such as signs, control panels, indicators, and flashlights.
These bulbs are small, but very bright, so they're often used in flashlights and optical instruments such as projectors and microscopes.
These miniature bulbs are sized to fit older telephone switchboards, signs, instruments, and indicators.
Offset pins on the base lock these bulbs into sockets. One pin is slightly higher on the base than the other pin.
Wire terminals allow you to connect these bulbs to a power source through a panel.
Fit these bulbs in tight spaces such as signs, control panels, indicators, and flashlights.
Use these bulbs in tight spaces, such as in indicators and vehicle lights.
Commonly used in signs, instruments, indicators, and flashlights.
Pins on the base lock these bulbs into sockets to withstand vibration.
Pins on the base lock these bulbs into sockets to withstand vibration. They're often used in machines and elevators.
Small as hockey pucks, these lightweight strobe lights mount to surfaces and are unobtrusive when they’re turned off.
Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.
A series of four flashes per cycle makes these lights more visible than other strobe lights.
As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.
Easier to spot than other strobe lights, these lights emit bursts of five flashes per cycle.
Set these portable lights wherever you need a signal light—they don't need to be wired or plugged in.
Mounted on a tripod, these lights stand higher for greater visibility than other strobe lights.
Direct your signal with these lights; they flash in one direction.
The pad below the base absorbs shock and vibration.
These lights cycle through three different flashing patterns.
Lights combine high-visibility strobes with a buzzer that warns workers of hazards even when they’re outside a direct line of sight.
The buzzer warns workers of hazards even when they’re outside a direct line of sight.
Direct traffic with these colored lights.
When motion is detected from both directions at a two-way corner, these lights flash to alert personnel and prevent collisions.
Mount these lights onto your vehicle.
Add these lights to a forklift to improve safety. They contain a turn light, brake light, and backup light.
Use these fixtures to mark vehicle sides and avoid misjudging clearance.
This light rotates 360° horizontally and 180° vertically to illuminate any spot around a vehicle.
A handle control lets you aim these spotlights from inside your vehicle.
These lights swing out from the wall to illuminate loading docks and trailers.
A sealed head and switch keeps these lights shining in wet environments. They swing out from the wall and adjust horizontally and vertically to illuminate loading dock and trailers.
Compared to other dock lights that can only adjust vertically and horizontally, these lights bend at any angle to direct light exactly where it's needed.