Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

With a flexible layer of rubber sandwiched between an oil-embedded bronze bearing and rigid metal shell, these bearings reduce wear and machinery noise.

Use where high loads and speeds are not required.

Graphite provides a layer of dry lubrication that can operate in high-temperature environments.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

A figure-8-shaped groove provides a flow path for lubricant, distributing it evenly along the bearing’s surface.

Grooves on the inside of the bearing provide a flow path for lubricant, distributing it evenly along the bearing’s surface.

Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

The oil in these bearings is suitable for incidental contact with food.

These bearings come with a traceable lot number and material test report. They are also known as Oilite® bearings.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Graphite provides a layer of dry lubrication that operates in high-temperature environments.

An aluminum shell adds strength.

These bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Furnished with a traceable lot number and material test report, these bronze bearings are strong, wear resistant, and excellent at handling shock loads.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Engineered for simultaneous linear and rotary motion, these bearings are used with round end-supported shafts.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard linear ball bearings.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Ball bearings create less friction than sleeve bearings, so they require less force to operate.

Sleeve bearings outperform ball bearings in dirty environments. Use them for low speed applications.

The shell, housing, and balls of these bearings are stainless steel for excellent corrosion resistance.

Designed to handle heavy loads, these bearings have higher load capacities than comparable standard mounted linear ball bearings for support rail shafts.

Outdoor as well as mild chemical environments are no problem for these bearings. They have stainless steel balls for corrosion resistance.

Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

Larger OD tolerances than standard press-fit bushings allow for finishing. Bushings should be machine ground.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.