Clear All
System of Measurement System of Measurement |
|---|
|
For Shaft Diameter For Shaft Diameter |
|---|
|
ID ID |
|---|
|
OD OD |
|---|
|
Maximum Speed Maximum Speed | Show |
|---|
|
Maximum Speed Maximum Speed | Hide |
|---|
For Load Direction For Load Direction |
|---|
 | Combined Radial, Thrust, and Moment |
Bearing Type Bearing Type |
|---|
 | Roller |
For Housing ID For Housing ID |
|---|
|
For Shaft Type For Shaft Type |
|---|
 | Round |
Lubrication Lubrication |
|---|
|
Seal Type Seal Type |
|---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
Construction Construction |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Lubricant Lubricant |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Roller Material Roller Material |
|---|
|
Seal Material Seal Material |
|---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
|---|
|
About Ball and Roller Bearings
More
Crossed-Roller Bearings
With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Sealed bearings block out dust and other contaminants better than open bearings, but retain more heat.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Features | Each | |
Sealed | |||||||||||
| 200 | 226 | 13 | Steel | 5,800 | 12,250 | 175 | Lubricated | 0° to 175° | Lubrication Groove, Lubrication Hole | 0000000 | 0000000 |