We will reply to your message within an hour.
Once concrete begins to set up and surface water reabsorbs, finish with a trowel to compact the top layer for a smooth, hard surface.
Push and pull freshly-poured concrete.
Slide these tools along the perimeter of poured concrete slabs to create a rounded edge for a finished appearance that resists chipping.
Create grooves in poured concrete slabs to control cracking caused by drying, settling, and freezing.
Use floats after edging and grooving to smooth the surface and allow trapped air and water to escape.
Drag these brooms along hardening concrete to create a rough surface for traction in slippery environments.
With a durable one-piece construction, these boxes have no seams or welds to crack and leak.
Improve the strength of your concrete mix by eliminating trapped air.
Also known as mortar hoes, the blade on these tools has holes to allow concrete to pass through as you mix.
Make removing form-board stakes easier.
Stakes provide a firm anchor for concrete form boards.
Spread, scrape, and shape mortar.
Remove hardened flecks of mortar, dirt, and other debris.
Rub these tools along the mortar between bricks for a uniform, finished appearance.
Roll these mixers where you need them.
A removable polyethylene liner with molded-in blades allows for easy cleaning. Stand is stationary.
Also known as Tapcons, these screws are often used to anchor parts to concrete, block, and brick. Assortments include a drill bit.
Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.
These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.
The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.