An oversized diameter allows for finishing to your exact requirements. The addition of nickel gives D2 tool steel better wear resistance than A2. This air-hardening material is often used for cutting blades, stamps, and forming dies. These rods and discs are decarb-free for a uniform surface that will consistently accept heat treating.

If you don't see the size you're looking for, please specify a length under additional rod lengths.

For technical drawings and 3-D models, click on a part number.

Certificates with a traceable lot number are available for these products. Download certificates from ORDER HISTORY after your order ships.

These standard saws have high-speed steel teeth to make circular cuts in wood, plastic, and metal. Attach them to a drill or drill press. An arbor with pilot drill (sold separately) is required.

For technical drawings and 3-D models, click on a part number.

The carbide teeth on these saws last up to twice as long as high-speed steel teeth when cutting fiberglass, plastic, wood, and metal such as aluminum, cast iron, steel, and stainless steel. Attach saws to a drill or drill press. An arbor with pilot drill (sold separately) is required.

Specially designed teeth cut faster than the teeth on standard hole saws. Teeth are high-speed steel for cutting wood, plastic, and metal such as aluminum, brass, steel, and stainless steel. Attach saws to a drill or drill press. An arbor with pilot drill (sold separately) is required.

The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth. Saws are for use on reinforced plastic, Kevlar, stone, brick, and other abrasive materials with high silicon content. Attach them to a drill or drill press. An arbor with pilot drill (sold separately) is required. To cut ceramic tile, you must use a 1/4" carbide-tipped pilot drill.

For technical drawings and 3-D models, click on a part number.

These saws have carbide-grit-coated teeth that cut ceramic tile, fiberglass, masonry, plastic, and composites. Attach them to a drill or drill press. An arbor with pilot drill (sold separately) is required.