Less aggressive than our standard epoxy removers, these solvent-based wipes remove uncured epoxy adhesives and solder paste. They are often used to wipe excess epoxy and paste off printed circuit boards and other electronic components.

Clean faster by heating these solutions up to 140°. After washing, parts can be rinsed with water.

The cleanest, safest way to blast. These blasters turn liquid CO₂ into dry ice pellets that remove paint, grease, and dirt—without releasing harmful abrasive media into the surrounding air. Since the pellets turn to gas on contact, there's no media left behind to clean up.

Ideal for light surface prep on metals, the dry ice pellets won't scratch or etch your material. Adjust the pressure and spray width for small or large surfaces, and fine-tune your settings in real time using feedback from the display. Do a test run before using these blasters on soft plastics, since the pellets may leave behind a texture. Opt for a blasting setup with conventional media for tough removal of heavy coatings, corrosion, or scale.

You don't need to order pellets to get started. The built-in pelletizer converts liquid CO₂ into blasting media as you work. Connect a 50 lb. or 75 lb. CO₂ tank with siphon tubes (sold separately). The system draws CO₂ only when you pull the trigger, so quick jobs won't drain your tank. Any unused CO₂ can be stored for later jobs. Set these blasters up in any well-ventilated space.

When super glue becomes a super mess. These removers clean unwanted beads or drops of instant-bond adhesives, even if they’re already cured. Or you can use them to soak bonded parts to separate them. Keep in mind, they can damage paint, coatings, and finishes, so use them with care.

This type of solution is good for use in spray washers where foaming can be a concern. It can be heated to 140° for faster cleaning. Dilute with water to make up to 40 gallons of solution.

Cut through the strongest of structural adhesives before they fully cure. These removers clean unwanted drips or spills from epoxy and urethane-based adhesives such as Gorilla Glue. They can damage paint, coatings, and finishes, so use them with care.