The saws in these kits have carbide-tipped teeth—the hardest in our hole saw offering—so they stay sharp up to twice as long as saws with high-speed steel teeth. They also cut through harder sheet metal, wood, and other materials. Each kit contains saws in different diameters for cutting perfectly round holes of various sizes. Often used to remove more material than drill bits, these saws are helpful for jobs such as creating cutouts for doorknobs or cables. Attach them to a drill or drill press with the included arbors.

Quick-change hole saw arbors use a simple push-and-turn motion to attach and detach the saw. This makes it easy to quickly change sizes, instead of having to screw a hole saw on and off.

Quick-release pilot drill bits are easy to remove—just pull them out of your saw without any special tools.

Quickly connect these saws to your drill or drill press with the built-in arbor. Saws have high-speed steel teeth for cutting wood, plastic, and metal. A _1/4" diameter pilot drill is included.

An extra-thick steel body with carbide teeth can cut through stainless steel structural framing and electrical enclosures. The built-in arbor makes these saws easy to attach to a drill or drill press. They come with a pilot drill that has a spring to push out the slug.

Cut holes in wood and plastic five times faster than standard hole saws and with fewer blade changes. The teeth on these saws are shaped to power through not only wood, particleboard, and plastic but also drywall, plaster, and even masonry. Made of carbide, the teeth are the hardest in our hole saw offering, so they stay sharp up to twice as long as high-speed steel teeth.

To attach these saws to a drill or drill press, you'll need an arbor with a pilot drill bit (sold separately). If you're using an arbor you already have, make sure the pilot drill bit is at least 3 _5/8" long.

Quick-change arbors don’t require an L-key or screwdriver to swap out a dull pilot drill bit—just pull back on the release collar.

The carbide teeth on these steel saws cut aluminum, brass, bronze, steel, and plastic sheets and last up to twice as long as high-speed steel teeth. The body widens at the top to prevent the saw from pushing through your workpiece. A built-in arbor makes these saws easy to attach to your drill press. The included pilot drill has a spring that pushes out the slug.

The diamond-grit edge on these hole saws cuts more accurately, leaves a smoother finish, and lasts up to twice as long as carbide-grit-coated teeth. Saws are for use on reinforced plastic, Kevlar, stone, brick, and other abrasive materials with high silicon content. Attach them to a drill or drill press. An arbor with pilot drill (sold separately) is required. To cut ceramic tile, you must use a 1/4" carbide-tipped pilot drill.