We will reply to your message within an hour.
Adjust the flow rate as needed.
A tapered needle gives you more precise control than standard flow-adjustment inline hydraulic valves.
Set your flow rate and then adjust it as necessary; these valves maintain flow rate despite pressure changes in the system.
Maintain a fixed flow rate even if pressure changes in the system.
Start and stop flow with a quarter turn of the handle. Also known as ball valves.
Lock the handle using a padlock.
Also known as check valves, these open to allow flow in one direction and close when flow stops or reverses.
When input pressure varies, use these valves to maintain a consistent pressure.
Turn the handle to direct flow between ports.
To set the pressure, unscrew the cap and turn the adjusting screw.
An external nut lets you adjust the pressure without disassembling the valve.
The pressure setting on these valves cannot be adjusted while they are installed.
Direct flow with an electronic signal.
These valves maintain a consistent pressure in a system when input pressure varies.
Set a specific pressure and these valves will maintain it.
Control the direction of flow or stop flow altogether.
Turn the knob to gradually adjust the amount of flow.
Add air and hydraulic fluid to high-pressure struts, tanks, and hydraulic accumulators—these fill valves withstand pressures up to 5,000 psi.
Regulate air, gas, and liquid pressure on food, beverage, and pharmaceutical lines with these valves—they’re 3-A certified to meet sanitary design standards.
Connect up to four rams and a gauge to a pump. Ram connections have flow-adjustment valves to adjust ram speed, or shut it off to temporarily hold a load.
Control the flow of oil to adjust ram speed, or shut it off to temporarily hold a load.