We will reply to your message within an hour.
Also known as captive standoffs, a recess under the hex clinches the panel for a strong hold that won't push, pull, or twist out. When mounted, the hex sits flush with the surface and the closed end creates a neat, finished appearance.
These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.
A recess under the hex clinches a panel for a strong hold that won't push, pull, or twist out. When mounted with a lever press, the hex sits flush with the surface and the open end creates a through hole.
Once the end is clinched in place, panels with keyholes easily slide on and off these supports.
With the end clinched in place, the prongs allow you to quickly snap a panel on and off these supports.
Also known as captive spacers, the splines on these bite into a panel for a permanent hold.
Maintain consistent alignment in mating parts by installing a pin in one part and a liner in the other.
The shoulder provides a consistent height reference point and keeps the pin from being pressed through the fixture.
Install these pins in a plate or table and mate with holes in a workpiece for precise alignment.
Encase these pins while molding plastic or composite parts. Once set, the knurls resist movement, letting you align the workpiece with precision on a plate or table.
The head on these pins slides side-to-side in one direction. Use one of these pins and one standard round-head pin to prevent jamming when loading and unloading workpieces with inconsistent hole spacing.