Wire gauge sizes 1 to 70 have a shank diameter that's slightly smaller than the reamer diameter. Wire gauge sizes 71 to 80 have a shank diameter that's equal to the reamer diameter.

Spiral-flute reamers have a right-hand spiral and a right-hand cut. They pull chips upward as they cut, so they’re often used in blind holes. Spiral flutes create a smoother finish than straight flutes and work well in keyways and other applications with an interrupted cut.

For technical drawings and 3-D models, click on a part number.

These reamers have a 1/4”-28 threaded shank. All have a built-in pilot with a 45° chamfer angle to maintain alignment in the hole.

For technical drawings and 3-D models, click on a part number.

Drill and finish holes in a single pass with these dual-purpose tools. The tapered tip gradually pierces your material to reduce friction, and the straight flutes make clean cuts without chipping or peeling the edge of the hole. Made from solid carbide, these drill reamers are strong and heat resistant. The flutes stay sharp even when cutting abrasive materials such as carbon fiber, fiberglass, and graphite. Use them in drill presses or other machines—carbide is brittle, and will break if used to drill by hand.